Gun Tests’ product coordination editor bought the gun through an EAA wholesaler, RSR Distributors. This raised several questions.įor one, was this truly a new gun? It was certainly sold to us as one. The conclusion was that the heads of two cases in two adjoining cylinders had separated, leaving the body of each case behind. We inspected the chambers and called EAA. But when attempting to fire groups with the magnum rounds, we ran into a problem: two of the chambers were blocked. On average, all groups fired at 15 yards with these rounds measured 1.5 inches or less. With the gate open, the cylinder simply rolled out the right side of the frame.įiring the EAA revolver resulted in very good accuracy at 15 yards using the. The cylinder was easily removed by pressing in the spring-loaded latch screw and pulling out the cylinder stud, which is much like an axle. The frame was nicely blued, and the stainless-steel hammer was two-tone, blued on the top and back, polished on the sides. The rear sight was a notch in the top strap that was revealed when the hammer was pulled back. The front sight was heavier and wider than we are accustomed to. The walnut grip had been contoured to offer a rest for the thumb of the right handed shooter. To lower the hammer safely, you must press the trigger with the thumb on the hammer, gently allowing the hammer to ease down. We do know it can lock when you do not want it to.įiring the Bounty Hunter is simply a matter of pulling the hammer all the way back and pressing the trigger. You can lock the ejector rod inside the cylinder by pushing up a tab, but we’re not sure if this is helpful. To eject rounds, simply repeat this process and push the ejector rod through each chamber. The Ruger, for example, requires far more hand-to-eye coordination, in our view. We liked the way the EAA’s cylinder indexes and wish other revolvers of this type would do the same. To index the individual chambers, rotate the cylinder until it clicks and insert a round. To load it, pull the hammer to half cock and open the loading gate. The $280 Bounty Hunter from EAA most resembled an old single-action design. More on this later.įor accuracy, we tested these 4.5-inch barrel single-action revolvers at 15 yards shooting long rifle cartridges by Federal and Remington and magnum rounds from CCI and Winchester. This process was uneventful, except when we found two of the chambers in the EAA’s magnum cylinder were blocked by pieces of shell casings. Each gun was cleaned and lubricated before firing. During this session we sought to determine not only how each gun liked to be shot but also the best way to swap cylinders, load and unload ammunition. Only time at the range would tell, and we were eager to get at it.Ī plinking session to become familiar with each gun preceded our bench rest session. Adding the more powerful magnum round could conceivably put more versatility in our hands, or it could merely be a shortcut to wear. Nonetheless, today’s gun-buying consumer could look at guns like the $149 Heritage Rough Rider, EAA’s $280 Bounty Hunter, and the less musically named Ruger New Model Single Six, $352, and find rimfires that evoke a spirit of shooting fun, despite the lack of any pure, Old West tie-in.īeing big fans of fun, we wanted to shoot these three models in two-cylinder configurations: one wheel for the. 22-caliber handguns, with names like Rough Rider and Bounty Hunter, that never existed as true cowboy-era firearms.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |